Universal Audio 4-710d Operations Instructions download pdf (Page 23)

Digital Clocking Primer

Digital clocking is a complicated issue, with a number of important aspects that are often not very

well understood.

First and foremost, a digital clock is used to maintain synchronization between different digital

devices. There are two primary purposes for clock synchronization:

1. Digital Conversion. Analog-to-digital (A/D) conversion and digital-to-analog (D/A) conversion need

extremely accurate clocking in order to correctly process the digital data. A low-quality clock can

degrade the signal in many ways, including loss of transparency, clarity, imaging and transient

response, as well as increased noise and distortion.

2. Digital Transmission. All digital devices need accurate clocking in order to properly transfer digital

data between interconnected devices. A low-quality clock can cause data reception errors, which

add distortion and noise, and if the clock isn’t synchronized correctly, samples may be dropped or

repeated, resulting in audible clicks or dropouts.

Clock quality is defined two ways: First, the sample rate must match the signal. This is referred to as

“sample rate synchronization.” Second, the clock signal must be stable over both short- and long-term

clocking intervals. “Jitter” refers to short-term clock accuracy, and “stability” or “drift” refers to long-

term clock accuracy. These terms are discussed in more detail below.

Sample rate synchronization is required for proper digital transmission, and is relatively easy to

maintain. Basically, there must be one and only one “clock master” for all interconnected digital

devices. This is done by setting one device to “master” mode (where it synchronizes to its internal

clock and transmits that clock signal) and setting every other device to “slave” mode (where it

receives and synchronizes to external clock), with the appropriate clock signal routed between the

master and slave devices. Keep in mind that any device, whether it’s the clock master or a slave, can

send or receive data once everything is synchronized correctly.

When doing digital conversion, it’s best to have the converter serve as the clock master. For example, if

you’re recording, clock everything off the A/D converter. Likewise, if you’re mixing, clock everything off

the D/A converter. If you’re running multiple converters, use the device with the best quality clock as

master.

For all-digital transfers, e.g., a digital transfer from one DAW or storage device to another, clock

synchronization is maintained by simply setting up the proper master-slave relationship between

devices. Digital transfers can be affected by clock jitter, but not in the same way clock jitter affects

analog conversion. This is a widely misunderstood concept we’ll discuss in detail below.

Clock jitter is short-term variations in the edges of a clock signal, as opposed to clock drift, which is

long-term variations in the clock rate. A clock could be very stable over the long term, but still have

jitter, and vice versa. Timing variations are caused by noise and/or interference. If the

noise/interference is a high-frequency signal, the result is jitter, and if the noise/interference is a low-

frequency signal, the result is drift. As an analogy, a car with an out of balance wheel may drive

straight, but you’ll get lots of vibration (jitter); conversely, a car with a loose steering wheel might

have a smooth ride, but it will drift all over the road.

Clock drift affects long-term synchronization, like sound to picture, and can introduce slight pitch

variations in the audio. Usually however, the drift is so slow that these pitch variations are only tiny

fractions of a cent, and thus unnoticeable.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 42 43

No comments

Universal Audio 4-710d Operations Instructions Page 23